Nameplate; Signs And Symbols Used; Classification Of The Warnings; Safety - Abicor Binzel FEC Originalbetriebsanleitung

FEC

1.3 Nameplate

Fig. 1
The device is labeled by means of a nameplate on the housing.
► For inquiries, please have at hand the device type, device number and year of construction per the
nameplate.

1.4 Signs and symbols used

The following signs and symbols are used in the operating instructions:
1
A

1.5 Classification of the warnings

The warnings used in the operating instructions are divided into four different levels and shown prior to
potentially dangerous work steps. The following signal words are used depending on the type of hazard:
Describes an imminent threatening danger. If not avoided, it may cause severe injuries or death.
Describes a potentially dangerous situation. If not avoided, this may result in death or serious injuries.
Describes a potentially harmful situation. If not avoided, this may result in slight or minor injuries.
NOTICE
Describes the risk of impairing work results or material damage and indicates irreparable damage to the
device or equipment.

2 Safety

This chapter describes the essential safety requirements and warns of residual hazards that should be kept
in mind to operate the product safely. Non-observance of the safety instructions may result in risks to the life
and health of personnel, and environmental damage or material damage.
Nameplate
General instructions.
Action(s) to be carried out in succession.
Lists.
Cross-reference symbol refers to detailed, supplementary or further information.
Caption, item description.
DANGER
WARNING
CAUTION
2 Safety
EN - 5