Transport And Installation; Ambient Temperature; Commissioning - Abicor Binzel FEC Originalbetriebsanleitung

5 Transport and installation

Tab. 2

Ambient temperature

(operation, storage in a closed environment)
Ambient temperature (transport)
Relative humidity
5 Transport and installation
Risk of injury due to improper transport and installation
Improper transport and installation can cause the device to tip or fall over. This may result in serious
injuries.
► Check and wear your personal protective equipment.
► Ensure that the extraction hose is laid in a straight line.
► Ensure that all supply lines and cables do not encroach into the area in which employees are working.
► Place the device on a suitable base (flat, solid, dry) on which it will not topple over.
► Note the weight of the device when lifting it.
► Use an appropriate lifting tool with load handling attachment for transporting and installing the
► Avoid abrupt lifting and setting down.
► Do not lift the device over persons or other devices.
NOTICE
Risk of material damage due to improper transport and installation
Improper transport or installation can cause the device to tip or fall over. This can result in material
damage and irreparable damage to the device.
► Protect the device against weather conditions, such as rain and direct sunlight.
► Ensure that the device does not make contact if you pass over edging.
► Use the device only in dry, clean and well-ventilated rooms.
► Maintain a minimum distance of 1 m from the wall when installing the device to ensure that the device

6 Commissioning

Risk of injury due to fire
Improper use or connection can result in fire. This may result in serious burns.
► Ensure that the operating voltage specified on the nameplate is suitable for the connection voltage.
► Do not use the device to extract welding fumes that result from welding oil-wetted parts.
► Do not use the device for extracting aggressive gases or glowing particles (smoldering nests or
► Do not use the device to extract flammable substances and liquids.
► Do not use the device in areas subject to dust or gas explosion hazards.
EN - 12
Ambient conditions for transport, storage and operation
WARNING
 4.3 Technical data on page EN-10
device.
has sufficient ventilation.
WARNING
similar).
0 °C to +40 °C
−15 °C to +40 °C
Up to 90% at +20 °C
Connect the welding torch system, extraction hose
1
and rubber connector to the device.
Plug in the mains plug.
2
FEC