For Run Mode: Folding Up The Handle Bar - SPORTSTECH sTread Fold Benutzerhandbuch

2.2 FOR RUN MODE: FOLDING UP THE HANDLE BAR

The sTread Fold can be used either in "Walk Mode" (maximum speed 6 km/h) or in "Run Mode"
(maximum speed 12 km/h). In Walk Mode the handles are not required, in Run Mode they must be used::
• Fold the latch (A) on the right side of the treadmill downwards/outwards.
• Fold up the support tubes (B) from their resting position.
• Fold the latch (A) on the right side of the treadmill upwards/inside.
Ensure that the support tubes are securely locked in place.
If the support tubes have too much or too little play,
adjust the clamping screw on the left side (see below).
• Press the locking button (C) inwards.
• Fold up the handle (D) into the horizontal position.
Ensure that the handle is securely locked in place.
1
3
2.4 MOUNTING / INSTALLING MOBILE DEVICE HOLDER
• Insert screws (' J ') into mobile device stand ('K') and tighten with Allen key.
• Place the screw cap ('L') over the upper end of the stand. Fasten holder ('M') with screw cap.
• Insert the screws of the holder assembly into the openings ('N') on the folded-up handle ('D').
After training: Pull the holder assembly out again before folding down the handle.
•
K
2.3 ADJUSTING THE PLAY OF
A
THE SUPPORT TUBES
If the support tubes 'B' have too much or too little play :
• Remove the cover cap ('E') on the lower left support tube and
store it safely.
• Push the supplied socket ('F') into the opening
so that it sits on the nut inside.
• Insert the supplied Allen key ('H')
through the holes in the socket.
• Turn the socket until the play
of the support tubes is minimal,
but they can still be folded without problems.
L
M
J
B
2
F
H
DE
EN
C
D
A
E
D
N
25