Setting Up, Storing - SPORTSTECH sWalk Benutzerhandbuch

SAFETY STICKERS
The safety stickers must be at the positions shown in the
following figure.
• Make sure they are always intact and fully readable.

2. Setting up, Storing

2.1 SETTING-UP
Find a location for the device that meets the following requirements:
• Dry interior
• Device does not cover any ventilation openings.
• Heat-resistant robust base; use floor protection mat if necessary
• Clearance of at least 2 m (6.6 ft) behind the device.
• Clearance of at least 1 m (3.3 ft) on both sides of the device.
• Clearance of at least 30 cm (1.0 ft) in front of the device.
2.2 OPTIONAL: FIXING THE PADS FOR STORING
• Loosen the two screws in the back of motor cover (see figure below).
• Attach the two pads to the groove. Fix them with the two screws by the Hex wrench provided.
2.3 STORING
• Store the device out of reach for animals and children.
• Store in dry and clean indoor environment.
Protect against direct sunlight.
Protect against dust.
22
WARNING!
Risk of injuries from moving belt !
• Keep children and animals away from the treadmill.
• Do not move fingers, feet or other limbs
or objects under the moving belt.
• Always wear suitable footwear for training.
• Make sure the belt is always properly
tensed and centered.
• Reduce speed to full stop before descending.
Risk of electrical shock !
• Do not open the motor cover.
• Use the device only on a properly grounded socket.
WARNUNG!
Verletzungsgefahr durch Laufgurt !
• Kinder und Tiere vom Laufband fernhalten.
• Finger, Füße oder andere Körperteile
nicht unter den Laufgurt bewegen.
• Immer geeignete Schuhe zum Training tragen.
• Sicherstellen, dass der Laufgurt immer korrekt
gespannt und zentriert ist.
• Vor dem Absteigen Laufgurt vollständig anhalten.
Gefahr des elektrischen Schlag !
• Motorabdeckung nicht öffnen.
• Gerät nur an korrekt geerdeter Steckdose nutzen.
1m
1 m
(3.3ft)
0,3m (1ft)
0,3 m
1m
1 m
(3.3ft)
2m
2 m
(6.6ft)