Connect To An External Audio System - Packard Bell Easy Hdd Recorder Handbuch

C - Connect to TV using video component (YUV or
YCbCr)
Video component gives by far the best image quality for LCD and
plasma TVs. In order to use video component connection, the
RECORDER must already be connected to the TV using one of the
previous connections (however, SCART is recommended).
1. Power on the TV and select the source corresponding to the
RECORDER.
2. Power on the RECORDER.
3. Connect the 3 component video cables (red, green, blue) from
the COMPONENT VIDEO OUT plugs (red, green, blue) on the
back of the RECORDER to the COMPONENT VIDEO IN plug
(red, green, blue) on the TV.
4. Connect audio cables from the AUDIO L/R OUT on the back of
the RECORDER to the AUDIO L/R IN on the TV.
5. Press MENU on the remote control.
6. Using the Navigation buttons, go to the GENERAL menu section.
7. Using the Navigation buttons and the OK button, change the
SCART Output setting to YCbCr. Change the Video output for-
mat setting to Progressive if the TV supports Progressive Scan.
8. Select YUV or YCbCr source on the TV.
9. The SCART cable can be unplugged.
C T A E
ONNECT O N XTERNAL
Analogue connection to an amplifier
Connect the audio cables (cinch) from the AUDIO L/R OUT (white/
red) connectors on the back of the recorder to the AUDIO L/R IN
(white/red) connectors on the back of the amplifier.
The following devices can be connected:
• Amplifier with Dolby Surround Pro Logic decoder
• Stereo amplifier
A - To audio out connectors.
B - To audio in connectors.
Getting Started - Installation
11 -
A S
UDIO YSTEM
Digital connection to an amplifier
Connect an optical cable from the OPTICAL OUT on the back of the
recorder to the OPTICAL IN on the back of the amplifier.
or
Connect a coaxial cable from the COAXIAL OUT on the back of the
recorder to the COAXIAL IN on the back of the amplifier.
Coaxial
OR
Optical
A. AMPLIFIER with DOLBY DIGITAL or DTS decoder
B. FRONT LEFT
C. CENTER
D. SUBWOOFER
E. FRONT RIGHT
F. SURROUND RIGHT
G. SURROUND LEFT
The following devices can be connected:
• Amplifier with Dolby Digital decoder
• Amplifier with DTS decoder
C AV O DV S
ONNECT AN R
P
ANEL
Flip down the door as indicated by the OPEN label at the right hand
corner.
1. USB connector
2. Use S-Video jack or composite video connector
3. Audio input connector
4. IEEE 1394 connector
F
IGNAL VIA THE RONT