YATO YT-44085 Originalanleitung Seite 10

EN
position to start cutting.
Holding the router securely, start it and wait until the bit reaches full speed.
Carefully start cutting, allowing the guide bushing to follow the slot pattern on the template (XIII). The result of the cut should look
like in fi gure XIV.
Caution! Do not cut slots individually, but instead make the cut in one process, carefully following the shape of the template.
Warning! When cutting, make sure that the bit does not come into contact with any part of the template. The bit should also not
be lifted before the cut is completed.
Once the cut is complete, turn off the router and wait for the bit to completely stop and remove it from the template.
After fi nishing the cut, slide the elements to be joined out of the template and check the joint made.
Caution! The correct joint should be neither too loose nor too tight. If the joints made are incorrect, or if you need to gain more
experience in making dovetail joints, cut off the joint made with a saw and try again.
If the joint is too tight, it may be helpful to strike it using low force with a wooden or rubber mallet to bring the pieces together.
MAINTENANCE
After fi nishing work clean the tool of the dust using a jet of compressed air with a pressure of not more than 0.3 MPa by using for
example industrial vacuum cleaner or soft brush. If the tool is soiled with resin, clean it with a resin remover. Store the tool in a
well-ventilated place protecting it from moisture and direct sunlight.
O R I G I N A L I N S T R U C T I O N S
10