Cameo F2 D IP Bedienungsanleitung Seite 17

DMX fail = Operational
status with
DMX signal
fault
Dimmer = Dimmer
curve curve
Dimmer = Dimmer
response response
LED Fre- = LED PWM
quency frequency
Fan = Adjust fan
control
Factory = Reset to fac-
Reset tory setting
Back
Hold Last command is retained
or blackout, Activates blackout
Full On Spotlight switches to full on
Standalone Stand alone mode is activated
Back
Linear Light intensity increases linearly with DMX value
Exponential Light intensity can be finely adjusted at lower
DMX values and broadly adjusted at higher DMX
values
Logarithmic Light intensity can be broadly adjusted at lower
DMX values and finely adjusted at higher DMX
values
S-curve Light intensity can be finely adjusted at lower
and higher DMX values and broadly adjusted at
medium DMX values
Back
LED Light responds abruptly to changes in DMX
value
Halogen Light behaves like a halogen spotlight with
slight brightness changes
Back
800 Hz / Configuration of LED PWM frequency
1200 Hz /
2000 Hz /
3600 Hz /
12 kHz /
25 kHz
Back
Car Automatic fan speed control
Off Deactivated fan with greatly reduced brightness
Constant Constantly low fan speed with reduced bright-
Low ness, if necessary
Constant Constant average fan speed with reduced
Medium brightness, if necessary
Constant Constant high fan speed
High
Back
Reset Now! Reset to factory settings
17