Cameo F2 D IP Bedienungsanleitung Seite 15

CONFIGURING DMX MODE (DMX Mode)
Press the encoder to access the main menu. Rotate the encoder to select the menu item DMX
Mode (left arrow) and confirm by pushing the encoder. You can now select the desired DMX mode
by rotating the encoder (5CH, 4CH, 3CH, 2CH 2, 2CH 1, 1CH). Confirm the selection by pushing the
encoder. Select the arrow symbol at the top of the menu for back and push the encoder to return
to the main display. The main display is activated automatically if no input is made within approxi-
mately 30 seconds. Tables with the channel assignment of the different DMX modes can be found
in these instructions under DMX CONTROL.
-------------- Menu --------------

DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
STATIC MODE
Press the encoder to access the main menu. Rotate the encoder to select the menu item Stand
Alone (left arrow) and confirm by pushing the encoder. Now select the submenu item Dimmer
and confirm by pushing the encoder and rotate the encoder to set the desired brightness with val-
ues between 000 (blackout) and 255 (maximum brightness). Confirm your entry by pressing the
encoder. A stroboscopic effect can now be activated as required and set in the same way (strobe
value 000 = strobe off. Value 001 = lowest flash frequency. Value 255 = highest flash frequency).
Now select the arrow symbol for back at the top of the submenu. Push the encoder and access
the main menu in the same way to return to the main display.
-------------- Menu --------------

DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
------------ DMX Mode ------------

5CH
4CH
3CH
2CH 2
2CH 1
1CH
----------- Stand Alone ----------

Dimmer <255>
Strobe <255>
DMX Address
001
000
Mode
Static
–
255
15