Cameo F2 D IP Bedienungsanleitung Seite 13

7 DIM/MENU
Rotary-push encoder for the adjustment and control of the spotlight.
DIM – If one of the DMX modes is enabled and there is no DMX signal to the device, the encoder
serves as master dimmer control and you can set the brightness of the spotlight with values from
000 to 255 by turning the encoder (Quicklight).
Quicklight
000–255
MENU – Push the encoder to access the main menu and select menu items by turning the
encoder.
---------------- Menu ----------------

DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
8 ZOOM
On either side of the cabinet is a calibration control to manually adjust the beam angle. The two
controls are mechanically linked and are directly opposite each other on the housing. Turn the
calibration control to adjust the beam angle of the spotlight continuously from 40° to 15°. A rack
and pinion system moves the zoom tube with the Fresnel lens in and out of the housing. The
further the zoom tube protrudes from the housing, the smaller the beam angle. A stop mechanism
prevents the tube from becoming detached from the housing.
ATTENTION: In order to provide protection from spraying water, in accordance with
protection class IP65, special IP65-rated XLR connectors must be used correctly with the
DMX input and output sockets, or they must be closed using the rubber sealing caps.
When connected correctly, or when sealed correctly with the rubber sealing caps, the
POWER IN and POWER OUT sockets are protected from spraying water, as in accordance
with IP65.
13