Final Assembly Of The Wide Backrest - Sirona Dental C1+ Installationsanleitung

16 Final Assembly of the Wide Backrest

16 Final Assembly of the Wide Backrest
1. Attach and snap on backrest cover.
2. Unscrew backrest padding from cardboard backing.
With the electrical headrest:
Remove the two red transport safety devices at the
right and left of the padding flap.
3. Hook the padding onto the two upper studs (with Torx
screws).
4. Pull down the padding backing in the lower hooking
area (do not let the padding come into contact with
edges A) and hook it onto the lower studs.
5. Press the padding to the right and left sides over the
outer contour of the rear cover while holding the cover
back with your hand.
The padding snap fasteners B must snap into place.
The edge contour of the padding towards the rear cover
must be uniform.
6. With the electrical headrest:
Press the Velcro strap in area C uniformly onto catch
D.
22
2.
B
B
C
6.
4.
A
3.
D
5.
Sirona Dental Systems GmbH
1.
59 06 602 D 3382
D 3382.031.01.02.02