Herunterladen Inhalt Inhalt Diese Seite drucken

Installing The Wide Backrest - Sirona Dental C1+ Installationsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

4 Installing the Wide Backrest

4
Installing the Wide Backrest
5.
1.
ATTENTION
The order of installation must be complied with exactly to
guarantee the parallelism of the guide rods on the slide of
the headrest.
1.
Remove the six screws and four washers from the
sword.
2.
Pull off the backrest cover.
3.
Pull out the headrest to its stop position.
4.
Place the metal bracket, tilted slightly backward, onto
point B and tilt the backrest forward.
5.
Pull the cable for the tilting part L15 out of the headrest
case.
6.
Fasten the backrest with the six screws removed under
item 1. .
i
NOTE
With the electrical headrest the padding flap P is fastened
with the two middle screws.
Never use washers.
8
3.
i
6.
P
B
4.
X5
7.
X4
7.
ATTENTION
Tighten all screws. Screws that are not tightened can lead
to functional disturbances when moving the headrest in and
out.
7.
Thread the cables with connectors X4 and X5 through
the holes and run them to the board.
Sirona Dental Systems GmbH
2.
59 06 602 D 3382
D 3382.031.01.02.02

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis