Final Work - Sirona Dental C1+ Installationsanleitung

Sirona Dental Systems GmbH

14 Final Work

6.
1. Set intermediate footswitch into place, push forwards
up to end stop and firmly attach with two screws,
washers and serrated disks.
2. The foot switch cable can either be shortened or
extended as required.
To do this, unscrew strain relief A and pull the cable to
the required length.
The excess length of the cable can be stowed away in
housing B.
Reattach strain relief with screws.
3. Fasten the bow of the foot switch with two screws.
Install the bellows
i
NOTE
To make the installation easier, the patient chair can be
moved up a little (see Operating Instructions).
When doing this, follow the Operating Instructions!
4. Unscrew the two screws C and washers on the back of
the chair.
5. Loosen and remove the fastening belt.
59 06 602 D 3382
D 3382.031.01.02.02
5.
B
8.
9.
C
1.
2.
A
ATTENTION
Lower the bellows carefully!
6. Attach the bellows.
7. Screw on the bellows at the back using two screws C
and washers.
8. Use two screws and washers to screw on the upper
cover plate.
Fasten bellows with screws ( C ).
9. Fit faceplace and small bellows.
14 Final Work
C
7.
3.
19