Preparing The Chair For Assembly - Sirona Dental C1+ Installationsanleitung

6 Preparing the Chair for Assembly

6 Preparing the Chair for Assembly
2.
3.
1.
1. Remove the front faceplate of the base.
It is fitted on the lateral faceplates (if necessary,
carefully pry the faceplates apart with a screwdriver).
2. Unscrew the two screws (with washers) at the front of
the cover. Take off the cover.
3. Remove the transport safety device.
4. Pull off the small bellows from the foot control.
Remove the rear faceplate of the base. It is fitted on the
lateral faceplates (if necessary, carefully pry the
faceplates apart with a screwdriver).
5. Unscrew the top faceplate (two screws with washers).
6. Separate the chair from the pallet:
Unscrew the six mounting screws (with washers).
7. Unscrew two screws (with washers) and remove both
lateral covers.
10
7.
6.
6.
6.
Sirona Dental Systems GmbH
5.
4.
59 06 602 D 3382
D 3382.031.01.02.02