Herunterladen Inhalt Inhalt Diese Seite drucken

MasterCool ULTIMA ID PRO Betriebshandbuch Seite 4

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Low Side Vapor Sample Hose
The 6.5 foot (2 meter) Low Side Vapor Sample Hose configuration is constructed of a polyurethane tube. A Brass Sample Hose
Restrictor acts to reduce pressure at the sample connection point and reduce the introduction of harmful oil into the machine. The
maximum inlet pressure is 500 psig. The hose is provided with an instrument inlet port mating connector on one end and a 1⁄4"
SAE female flare coupling nut on the service end.
NOTE: The analyzer will indicate "Non-Condensable" or "Unknown Refrigerant" if the analyzer does not receive a good sample
due to obstructed flow or lack of flow. If this occurs the Brass Sample Hose Restrictor may need to be replaced.
Analyzer End
High Side Liquid Sample Hose
The 6.5 foot (2 meter) High Side Sample Hose configuration is constructed of a polyurethane tube with an oil reservoir. A Brass
Sample Hose Restrictor acts to transform Liquid refrigerant to Vapor at the sample connection point while the High Pressure Liq-
uid Sample Trap Assembly collects oil and provides a means of expulsion after the test is complete. The syringe is provided with a
magnet for attaching it to the tank, an instrument inlet port mating connector on one end and a 1⁄4" SAE female flare coupling nut
on the service end. The maximum pressure is 500 psig.
NOTE: The analyzer will indicate "Non-Condensable" or "Unknown Refrigerant" if the analyzer does not receive a good sample
due to obstructed flow or lack of flow. If this occurs the Brass Sample Hose Restrictor may need to be replaced.
Analyzer End
AC Power Adapter
The Ultima ID Pro™ is powered via a Lithium Iron Phosphate battery. You can also power the unit via the 90-264 VAC, 50-60
Hz power transformer. This transformer is included with each unit and converts a standard 100-240VAC 50/60Hz wall outlet to
4
Brass Sample
Hose Restrictor
Brass Sample
Hose Restrictor
www.mastercool.com
Service End
(1/4 SAE Flare Nut)
High Pressure
Liquid Sample Trap
Assembly
Service End
(1/4 SAE Flare Nut)

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für MasterCool ULTIMA ID PRO

Diese Anleitung auch für:

69hvac -pro2

Inhaltsverzeichnis