Software-Updates; Low Battery Warning - MasterCool ULTIMA ID PRO Betriebshandbuch

paper roll should be changed when a red stripe appears on the left side of the printout.
To change the paper roll, press the 'SET' button shortly after powering the analyzer on or any time it appears. The screen will dis-
play several options as shown in (Figure 29). Press the 'FEED' button to advance to the screen shown in (Figure 30).
Open the printer door and remove the old roll by tearing the paper as it enters the printer then pressing the 'FEED' button shown
in (Figure 30) until the old roll exits the printer completely. Insert the new paper roll from the underside as shown below:
Press the 'FEED' button shown in (Figure 30) to automatically advance the paper through the printer. Allow at least 3 in (7cm) of
paper to exit the top of the printer. Press the 'DONE' button to stop the printer from advancing the paper. This will take you back to
(Figure 29). Slide the paper through the slot in the printer door and close the door.
3.5 Software Updates
From time to time, software updates may be made available to improve operating performance or add additional features. Some
updates will be provided at no charge to implement operating efficiencies while others will be optional, paid upgrades, to add new
refrigerants etc. Many of the updates can be completed by the user; however some will require the instrument to be returned to
the factory for new gas calibrations.
The Ultima ID Pro™ has a USB update port located on the Back Panel Connections. This port should not be used for any other
purpose other than to install factory updates using the Mastercool factory USB drive. IF YOU DO NOT REGISTER THE ANALYZ-
ER WE WILL NOT BE ABLE TO INFORM YOU OF ANY SOFTWARE UPDATES!

3.6 Low Battery Warning

A battery warning will occur when the internal Lithium Iron Phosphate battery voltage becomes low (Figure 31). You can either
continue working or connect the 12V AC Power Supply and continue to work by pressing 'IGNORE. The analyzer will charge the
battery while it is connected to the AC Power Supply but if you wish to use it wirelessly press 'OFF', plug the analyzer into the AC
Power Supply via the 12DC Outlet Input on the Back Panel and allow it to fully charge. Full charge will take at least 2 hours.
12
TO FEED IN A
NEW PAPER ROLL
PRESS FEED
PRESS SET TO
ADJ LCD CONTRAST
BACK FEED SET
Figure 29
www.mastercool.com
TO LOAD PAPER
1.
PRESS FEED
2. INSERT PAPER
3. PRESS DONE
TO EXIT
FEED DONE
Figure 30