Troubleshooting - Saeco Onda Übersetzung Der Originalanleitung

Problem
Machine does not turn on.
Indicator light ❿ off.
The machine makes a strange
noise.
Machine does not dispense.
The light are on but no coffee
comes out.
Coffee is dispensed only in drops
or not correctly dispensed.
Water spills out the drops collec-
tion pan.
There are signs of water at the
bottom of machine.
A slight hiss can be heard after
the coffee has been released.
Machine blocked.
The capsule insertion handle will
not open.
The table above table lists the solutions to problems that may occur. For other failures not included in the above
table, contact the nearest authorised service centre.
An independent Institute verified the CE Conformity of this equipment to the Directives 2014/30/EU and 2014/35/
EU.
This product also conforms the 2011/65/UE e 2009/125/CE directives and regulation CE n°1935/2004.

TROUBLESHOOTING

Possible causes
Machine not connected to the
mains.
Electrical problem.
Coffee dispenser blocked.
High water level in the pan.
Carry out a pour operation while
the machine is empty.
Solution
Connect the machine to the mains;
Make sure that the rating values
match the mains rating.
Check that there is water in the tank
⓫.
Make sure that the handle ❶ is
totally closed and check the water
level in the tank ⓫.
The capsule inserted may be faulty.
Wait for a few seconds than try again
with a new capsule.
Carry out a washing cycle for the cof-
fee dispenser.
Empty the pan and resume regular
operation.
Make sure that the tank ⓫ has been
filled correctly into position.
This is not a fault, but normal setting
of the pressure control valve.
If the problem persists, please con-
tact your nearest assistance centre.
EN
23