24
2.4 Programming procedure
A
A Setting the time of day
B Setting the water hardness
The display shows three different measures:
The time
regeneration or recharge time
B
C
The display shows the time in hours and minutes
The initial display on start up of bestsoft 4/11 is 00:00.
The first two digits
prompting the installer to set the time with the [UP] and
[DOWN] keys.
Pressing the [SET] key confirms the entry.
The digits showing the minutes are flashing now. The
minutes are set by using the [UP], [DOWN] keys.
Pressing the [SET] key confirms the entry.
The display has moved into the Set Hardness mode. The dis-
play default is 300 ppm
ting suitable for hard water with a value of 300 parts per
million of hardness minerals.
Use the [UP] [DOWN] keys to adjust the setting.
Pressing the [SET] key confirms the entry.
, the hardness of the water
(Time; A)
( Recharge Time, C)
(showing the hours; HH)
(typical hardness level)
and the
(Hardness; B)
.
(HH:MM)
of the display will flash
which indicates a set-