Acquisition Unit; 5.1 Pairing The First Radio Module Of The Cerec 3 Milling Unit - Sirona CEREC AC Installationsanleitung

5 Pairing radio modules of the CEREC 3 milling units with those of the CEREC AC acquisition unit

5.1 Pairing the first radio module of the CEREC 3 milling unit

8
Installation Instructions for Pairing the Radio Modules HW8614/F2 and
5
Pairing radio modules of the CEREC 3
milling units with those of the CEREC AC

acquisition unit

Pairing radio modules of the CEREC 3 milling units with those of the CEREC AC acquisition unit
5.1
Pairing the first radio module of the CEREC 3
milling unit
Pairing the first radio module of the CEREC 3 milling unit
✔
A 8612/F2 radio module is connected to the CEREC 3 milling unit.
✔
A 8614/F2 radio module is installed in the CEREC AC acquisition
unit.
✔
The acquisition unit is switched on and the operating system has
booted up.
✔
The "SubsControl" program has started (see "Installing the
supplied programs [ → 5]").
1. If the "SubsControl" program has not started, insert the installation
CD and start the "Setup.exe" program. Follow the instructions on
the screen and click "Next", followed by "Install" and "OK", until
the "SubsControl" program is started.
2. In the window for the "SubsControl" program, click the "Start
subscription mode" button.
Sirona Dental Systems GmbH
62 80 064 D 3492
D 3492.031.02.02.02 06.2012