Connecting Radio Module Hw8614/F2 To Milling Unit Cerec Mc Xl - Sirona CEREC AC Installationsanleitung

Sirona Dental Systems GmbH
Installation Instructions for Pairing the Radio Modules HW8614/F2 and HW8612/F2 CEREC AC
62 80 064 D 3492
D 3492.031.02.02.02 06.2012

1 Connecting radio module HW8614/F2 to milling unit CEREC MC XL

1
Connecting radio module HW8614/F2 to
milling unit CEREC MC XL
1. Plug a connector of the supplied LAN cable into the LAN socket on
Connecting radio module HW8614/F2 to milling unit CEREC MC XL
the milling unit. The LAN cable supplied is a crossover LAN cable.
2. Plug the other end of the supplied LAN cable into the LAN port on the
radio module.
3. Connect the radio module to the mains using the power supply
provided.
4. Screw the rod antenna firmly into the antenna connection on the radio
module and align it in a vertical position.
5. Place the radio module close to the milling unit in a position in which
it can send and receive uninterrupted radio signals.
3