Sirona CEREC AC Installationsanleitung Seite 31

Sirona Dental Systems GmbH
Installation Instructions for Pairing the Radio Modules HW8614/F2 and HW8612/F2 CEREC AC 5.2 Pairing another radio module of the
62 80 064 D 3492
D 3492.031.02.02.02 06.2012
5 Pairing radio modules of the CEREC 3 milling units with those of the CEREC AC acquisition unit
8. When "Subscription mode started" or "OK" is displayed as the
last message, press and hold the black C button on the radio module
of the CEREC 3 milling unit for at least 6 seconds.
9. When the red LED B starts to flash, release the button.
 The pairing process is now underway.
 When the pairing has been performed successfully, the "SWAP
Service Configuration" window opens automatically. In
this window, you need to assign a virtual COM address to the
newly paired serial radio module.
10. Select one of the two new COM interfaces (e.g. COM8) and confirm
"OK"
with .
11. Stop the Swap Service Configuration with
12. Click the "Stop subscription mode" button in the
"Subscription Control" window to complete the pairing
process.
13. Close the window to exit the program.
14. Start the CEREC SW 4.x software and establish the connection to the
CEREC 3 milling unit in
the COM7 connection and confirming with
 The pairing is now complete.
"OK"
.
"Configuration" "Devices..."
>
"OK"
.
, by selecting
13