Connecting Radio Module Hw8612/F2 To Milling Unit Cerec 3 - Sirona CEREC AC Installationsanleitung

2 Connecting radio module HW8612/F2 to milling unit CEREC 3

B
A
RS-232
4
Installation Instructions for Pairing the Radio Modules HW8614/F2 and HW8612/F2 CEREC AC
2
Connecting radio module HW8612/F2 to
milling unit CEREC 3
1. Plug the connector for the power supply A into the radio module.
Connecting radio module HW8612/F2 to milling unit CEREC 3
2. Plug the connector B of the RS-232 cable into the radio module and
screw firmly into place.
3. Plug the connector at the other end of the RS-232 cable into the
COM1 interface on the milling unit and screw firmly into place.
4. Place the radio module with the pre-mounted magnetic strips on the
milling unit.
Sirona Dental Systems GmbH
62 80 064 D 3492
D 3492.031.02.02.02 06.2012