Fitting The Circle Cutter; Handling The Circle Cutter - Parkside PPKS 35 B3 Bedienungs- Und Sicherheitshinweise

z Fitting the circle cutter
Screw the rod of the circle cutter
torch holder with Bakelite inner ring
fit the magnetic holder
in Figure A�
NOTE! Bakelite is a durable, heat-resistant plastic�
z Handling the circle cutter
Attach the circle cutter
3 or metal pin
punch) on to the metal surface to be processed� Before
you can insert the plasma burner of your PPS 40 B3
plasma cutter or of your PSPP 5 A1 pilot ignition
conversion set into the torch stand with Bakelite inner
ring 5 , you must first remove the spacer of the
plasma burner, by pushing it down away from the
ceramic part as shown in Fig� H� The plasma torch
can now be inserted into the torch holder with Bakelite
inner ring
screw 2 on the magnetic holder
you can continuously adjust the diameter of the circle
cutter 1 � When setting a small diameter make sure
that when the plasma torch is being used, it will not
collide with the fixing screw
the magnetic foot
electrical devices� Make sure that you do not touch the
hot plasma torch by accident�
RISK OF BURNS!
4 (during preparation for each centre
5 , as shown in Figure B� Using the fixing
3 to the plasma cutter itself or other
1
3 or metal pin
1 using the magnetic holder
3
2 (Fig� E)� Never attach
GB
an den to the
5 (Fig� D)� Now
4 , as shown
/ metal pin 4
21