Assembly; Fitting/Changing The Cutting Disc; Fitting/Setting The Rip Fence; Fitting The Water Inlet Hose - Parkside PDFS 1300 A1 Gebrauchsanweisung, Originalbetriebsanleitung

Assembly

Fitting/changing the cutting disc

WARNING! RISK OF INJURY!
■ Switch the appliance off and remove the
power plug before starting any work on the
appliance .
NOTE
■ Only use diamond cutting discs with diame-
ters corresponding to the inscriptions on the
appliance .
♦ Set the cutting depth (using the locking screw
) to the minimum position .
♦ Actuate the spindle lock
screw until the spindle lock
place . Loosen the clamping screw / washer
with the hex key
screw / washer and the clamping flange
(see also fold-out page, fig . A) .
♦ Remove the cutting disc
♦ Fitting a cutting disc
reverse order .
♦ Actuate the spindle lock
screw until the spindle lock
place . Use the hex key
clamping screw .
WARNING!
► The arrow on the cutting disc
the direction of rotation arrow (running direc-
tion, marked on the appliance) .
■ Make sure that the cutting disc
the speed of the tool .

Fitting/setting the rip fence

♦ Undo the wing screw
into the rip fence slot
PDFS 1300 A1
and turn the clamping
clicks into
. Now remove the clamping
.
is carried out in the
and turn the clamping
clicks into
to firmly tighten the
must match
is suitable for
and insert the rip fence
.
♦ Set the desired cutting width using the scale on
the rip fence and the rip fence slot
rip fence slot serves as an orientation mark
(see also fold-out page, fig . E) .
♦ Retighten the wing screw

Fitting the water inlet hose

WARNING!
► Check the correct function of the residual
current circuit breaker
► Work with the appliance in a horizontal
position and not overhead to prevent water
from entering the machine .
► Before each use, check the water supply
system for leaks .
CAUTION!
► Do not connect the appliance to a water
supply system with more than 6 bar!
► Only use water as coolant .
♦ Set the cutting depth (using the locking screw
to the minimum position .
♦ Using a Phillips screwdriver and the accessory
screw supplied , fit the water inlet
housing (see also fold-out page, fig . B) . Please
note that the water inlet
around the cutting depth adjustment . The two
water outlets of the water inlet
ed on the side of the cutting disc
fold-out page, fig . F) .
♦ Push the water inlet hose
inlet .
♦ Insert the other end of the water inlet hose
into the water connection adapter
♦ Connect the water connection adapter
water hose with a suitable diameter of approx .
19 mm . Check for a tight fit by pulling on the
water hose .
♦ Open the valve
♦ Carefully adjust the amount of water at the water
source so that there is always enough water on
the cutting disc and the cutting area .
♦ Disconnect the water supply after completion
of the work .
. The
.
before each use!
to the
must be guided
must be locat-
(see also
into the water
.
on the water inlet .
GB │ IE │ NI │
)
to a
9 ■