Instructions For Conversion - Parkside PPKS 35 B3 Bedienungs- Und Sicherheitshinweise

z Instructions for conversion:
The pre-fitted Bakelite inner ring with larger internal
diameter 10
ring 5 is compatible with the pilot plasma burners
of the PPS 40 B3 plasma cutter, as well as the PSPP
5 A1 pilot ignition conversion set� By replacing the
pre-fitted Bakelite inner ring with larger internal
diameter
10
with smaller internal diameter supplied
circle cutter
contact plasma burner of the PPSK 40 as well as
with the PPS 40 A1 + B2 plasma cutters�
Conversion:
First undo the screw
remove the locking ring
screwdriver if necessary�
ATTENTION! KEEP YOUR FINGERS
AWAY FROM THE NOTCH OF THE
LOCKING RING
INJURY!
The Bakelite inner ring with larger internal
diameter 10
locking ring
out of the torch stand
inner ring with smaller internal diameter
the torch stand
doing this, the thicker edge of the Bakelite inner
22
of the torch stand with Bakelite inner
with the separate Bakelite inner ring
1 can be converted for use with the
7
can be easily removed after the
8 has been removed by lifting it up
5
5 from the top as well� When
GB
with the Allen key
8
� To do this use a flat
. DANGER OF
8
� Now insert the Bakelite
9 , the
6 � Then
9 into