Selecting Compressed Air Supply; Procedure When Using An External Compressor; Connecting The Cutting Torch; Connecting The Ground Cable - Parkside PPSK 40 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

• Selecting compressed air
supply
Press the selector switch for the compressed
air supply 10 in order to select the com-
pressed air source.
In INT position (Figure J) the compressed

air supply is provided by the integrated
compressor. In EXT position (Figure K) by
an external compressor.
When using the integrated compressor,

switch the toggle switch for external
compressed air 18
position (Figure L).
• Procedure when using an
external compressor
PLEASE NOTE!
For plasma cutting, a pressure of
4–4.5 bar is recommended. Adjust this
accordingly on your compressor. Please
bear in mind that the pressure can lower
while setting the air pressure. Thus, in
a hose length measuring 10 m and an
internal diameter of 9 mm it drops by
approx. 0.6 bar.
The compressed air source must have a fi lter
and regulator.
Connect the compressed air hose

the back of the plasma cutter
compressed air connection
insert the side of the compressed air hose
into the compressed air connection
the plasma cutter
connector (see Fig. I).
The pressure can be adjusted using the

pressure regulator on your compressor.
Select a pressure of 4–4.5 bar.
In order to release the compressed air

hose 20 , you must press the locking
to the "closed"
20 on
1 to the
17 . To do so,
17 of
1 without a quick
mechanism of the compressed air
connection 17 and pull out the com-
pressed air hose
(see Fig. I).
Switch the toggle switch for external

compressed air 18
(Figure M).

• Connecting the cutting torch

Insert the plasma burner plug

plasma burner connection socket
tighten the plasma burner plug hand-tight
7 (see Fig. A+B).
Insert the plasma burner power plug

into the plasma burner power socket
and tighten the union nut hand-tight
(see Fig. A+B).

• Connecting the ground cable

Connect the ground terminal plug
the ground terminal - connection socket
Make sure that the connecting shaft is fi rst
connected and then turned. The connecting
shaft must face upwards when plugging in
the ground cable plug
the connecting shaft must be rotated in a
clockwise direction until it reaches the stop,
in order to lock it in place (see Fig. A+B).
This does not require force!
• Fitting the removable roller
guide (optional)
Push the removable roller guide
nozzle clamping sleeve
screws are completely above the black
19a
area of the plasma burner
gap at the back of the nozzle clamping
sleeve 8b ) (see Fig. A+B). Now fi x the
locking screws . The guide rollers
19a
now positioned such that the required
GB/IE/NI/CY/MT
Before use
20 at the same time
to the "open" position
7 into the
13 and
6
11
5 with
12
5 . After plugging in,
19 over the
8b , until the locking
8 (behind the
are
19c
17
.