Warranty Coverage; Maintenance Table; Troubleshooting - Stiga LT 500 Li 48 Gebrauchsanweisung

12. WARRANTY COVERAGE

The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover damage caused by:
• failure to become familiar with the
documentation accompanying the machine;
• carelessness;
• incorrect or forbidden use or assembly;
• use of non-genuine spare parts;

13. MAINTENANCE TABLE

MACHINE
Check all fasteners
Safety checks/check controls
Check the cutting means guard.
Checking the cutting means
Check the battery charge status
Recharge the battery
Cleaning the machine and the engine
Checking for any damage to the machine. If
necessary, contact the authorised service centre.
* Refer to the battery/battery charger manual.

14. TROUBLESHOOTING

PROBLEM
1. The cutting means
is stationary and the
machine does not start
when the throttle control
lever and throttle safety
lever are engaged
2. Motor overheating
3. Grass accumulates
around the power
unit housing and the
cutting line head
Intervention
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
Low battery
The separable rod was not fully or
properly inserted in its housing
Defective throttle control lever/
throttle safety lever
Machine damaged
Grass trapped under the
cutting means guard
Too high grass is being cut
close to the ground
• use of attachments not supplied or
not approved by the manufacturer.
The warranty does not cover:
• normal wear and tear of consumables,
such as cutting means, safety
bolts; Normal wear and tear.
The purchaser is protected by his or her own
national legislation. The purchaser's rights under
the national laws or his or her own country are
not in any way restricted by this warranty.
Frequency
Before each use
Before each use
Before each use
Before each use
Before each use
After each use
After each use
After each use
Make sure that the battery is
inserted correctly (para. 7.2.3)
Check the battery status and recharge
if necessary (para. 7.2.2)
Make sure the separable rod was
and correctly inserted (par. 4.2)
Do not use the machine. Immediately turn
off the machine remove the battery and
contact an authorised service centre.
Do not use the machine. Immediately turn
off the machine remove the battery and
contact an authorised service centre.
Remove trapped grass (par. 6.5)
Cut tall grass with a sweeping
motion to avoid build up.
EN - 16
Notes
para. 7.4
para. 6.2
par. 6.2.1
par. 6.2.1
*
para. 7.2.2
*
para. 7.3
-
SOLUTION
installed