Starting The Charging Process; Completing The Charging Process; Initial Use; Adding Staples - Parkside PAT 4 D5 Originalbetriebsanleitung

Do not continuously pull the trigger
built-in rechargeable battery.
Set the On / Off switch
be used or will be stored for extended periods.
Note: If the charge indicator
is below 30 % and the battery must be recharged.
Starting the charging process (see Fig. A)
Connect the USB cable
Connect the other end of the USB cable
socket on the product.
2
Connect the charger
source. The charge indicator
will light up red whilst charging. Once the battery is charged up, it
lights up green.

Completing the charging process

Disconnect the charger
Disconnect the USB cable
the product.
Note: The product cannot be used whilst charging. It is normal
for the handle to warm up slightly whilst charging.

Initial use

Adding staples

Set the On / Off switch
the product.
Turn the product over.
Squeeze the release button
to prevent damaging the
1
to the "0" position if the product will not
8
lights up red during use, the charge
9
to the USB port
7a
to a 100–240 V∼ 50 / 60 Hz power
7
shows the charging progress. It
9
from the power source.
7
from the USB Type C socket
7a
to the "0" position before working on
8
(see Fig. B).
3a
of charger 7 .
7b
to the USB Type C
7a
GB/MT
on
2
67