Herunterladen Inhalt Inhalt Diese Seite drucken

Original Accessories/Auxiliary Equipment; Before Use; Charging The Battery Pack (See Fig. A); Attaching/Disconnecting The Battery Pack To/From The Appliance - Parkside PAT 20-Li A1 Originalbetriebsanleitung

Akku-tacker
Vorschau ausblenden Andere Handbücher für PAT 20-Li A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Original accessories/auxiliary
equipment
Only use the accessories and additional
equipment that are specified in the oper-
ating instructions and compatible with the
appliance.
WARNING!
Do not use any accessories not recom-
mended by PARKSIDE. This can lead to
electric shock and fire.

Before use

Charging the battery pack
(see fig. A)
CAUTION!
Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
Connect the battery pack
battery charger
Insert the power plug into the socket.
The control LED
The green LED
indicates that the charging
process is complete and the battery pack
is ready.
PAT 20-Li A1
to the high-speed
(see fig. A).
lights up red.
ATTENTION!
If the red control LED
that the battery pack
cannot be charged.
If the red and green control LEDs
flash, this means that the battery pack
defective.
Push the battery pack
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
Allow the battery pack
the appliance.
Removing the battery pack
Press the release button
battery pack
.

Checking the battery charge level

Press the battery charge level button
check the status of the battery (see also main
diagram).
The status will be shown on the battery display
LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
flashes, this means
has overheated and
both
is
into the appliance.
to click into place in
and remove the
to
GB │ IE │ NI
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis