Parkside PAT 4 D5 Originalbetriebsanleitung Seite 69

Set the On / Off switch
product off.
Note: Hold tool firmly and press on work surface before firing to
ensure the complete penetration of the staple / nail.
Clearing Jammed Staples
It may otherwise accidentally be triggered after removing the staple.
Note: Set the On / Off switch
jammed staple.
Open the magazine
Remove the jammed staple from the magazine
Note: Do not trigger the staple gun when empty to prevent wear.
Determining the Staple Length
Consider two factors when determining the correct staple length:
- the thickness of the material being fastened
- the composition (hardness) of the material being fastened.
4–6 mm staple or 6–8 mm nail in length will typically suffice when
driving into plywood and fiber board.
8–12 mm staple or 10 mm nail in length will typically suffice when
fastening into softwood such as pinewood.
to the "0" position to switch the
8
If a staple is jammed, do not squeeze the trigger
to "0" position prior to clearing the
8
and pull back on the pusher
4
1
.
3
.
4
GB/MT
.
69