Service; Appliance-Specific Safety Instructions For Electric Staple Guns; Before Use; Filling The Magazine - Parkside PET 25 C3 Originalbetriebsanleitung

5. Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
Appliance-specific safety
instructions for electric staple
guns
■ Always check that the power tool contains
staples.
Careless handling of the staple gun can lead to
unexpected ejection of staples which could
cause injuries.
■ Never aim the power tool at yourself or other
people in the vicinity. Unintended triggering
will cause a staple to shoot out, which can lead
to injuries.
■
Do not activate the power tool until it is
pressed firmly against the workpiece. If the
power tool is not in contact with the workpiece
the staple can rebound off the fastening point.
■ Disconnect the power tool from the mains or
battery if a staple becomes jammed in the
power tool. If the staple gun is connected to a
power source, it could be unintentionally acti-
vated while removing a jammed staple.
■ Be careful when removing a jammed staple.
The system may be live and the staple could be
forcefully ejected while you are attempting to
unblock the jam.
■ Never use this staple gun for fastening elec-
trical cables. It is not suitable for the installation
of electrical lines, can damage the insulation of
electrical cables and thus cause electrical
shocks and increase the risk of fire.
PET 25 C3
WARNING!
■ To avoid risks, damaged mains cables of the
appliance should be replaced by the manu-
facturer or the manufacturer's customer
service department or a similarly qualified
person.

Before use

NOTE
► Only fill the magazine when the appliance is
switched off! Set the ON/OFF switch
the position "0" and pull out the plug!

Filling the magazine

♦ Squeeze the magazine slider
♦ Pull the magazine slider
magazine of the appliance (see fig. B).
♦ Fill the magazine
(see fig. C).
♦ After filling, push the magazine slider
into the magazine
hear and feel it click into place.
NOTE
► When filling with nails, use the right shaft
(as shown in fig. C). Ensure that the nail
heads are always at the top.
► Note the maximum fill level of approx.
85 staples or approx. 75 nails.
► If the red line on the front of the magazine
slider coincides with the marking of the fill
4a
level indicator 8a , then the magazine is
empty.
to
(see fig. A).
out of the
with staples or nails
back
as far as the stop and you
GB │ IE │
5 ■