Replacing The Tool Magazine Inserts - VHF K4 edition Originalbetriebsanleitung

Machine maintenance and cleaning
NOTICE
Tool breakage or incorrect results caused by
loose screws
If the blank is mounted into the blank holder too loosely, the
measurement results may become incorrect or the tool may
break during calibration.
h Tighten the screws of the fixing ring firmly.
M1. Mount a calibration disc into the blank holder.
S2. Mill the calibration / test specimen as described in the
documentation for the manufacturing software.
– After milling the calibration / test specimen looks as
follows:
Fig. 30: A milled calibration / test specimen for the K4 edition
M3. Unmount the calibration / test specimen from the ma-
chine.
S4. Follow the instructions on calibration in the documen-
tation for the manufacturing software.
M5. After the calibration, remove the calibration tool from
the machine and keep all parts of the calibration set for
further use.

6.11 Replacing the tool magazine inserts

When the tool magazine inserts are worn, they should be re-
placed. Afterwards you must drill the tool positions into the
new inserts with the Machine.
Your Machine comes with tool magazine inserts as
„
spare parts and with the drill tool.
Additional inserts and drill tools are available via cus-
„
tomer service.
h Always replace all inserts together even if only individual
inserts are worn. The machine will always drill the tool
positions for all inserts.
28
b
M1. Have the tool magazine inserts ready as spare parts.
M2. Open the working chamber door.
M3. Remove all tools from the tool magazine.
M4. Loosen the 4 screws on the upper side of the tool mag-
M5. Remove the 7 existing tool magazine inserts and re-
M6. Put the cover back onto the tool magazine and screw it
S7.
Fig. 31: Loosening the screws and lifting the cover
Original Operating Instructions: K4 edition
Document version: E – 02/2020
The documentation for the manufacturing software
contains step-by-step instructions for drilling the in-
serts. Below you find a description of how to replace
the tool magazine inserts in the machine.
azine and lift the cover (

place them with new ones (
down with the screws that you untightened in step M4.
Follow the instructions in the documentation for the
manufacturing software and drill the tool positions in
the new inserts.
Fig. 31).
Fig. 32).
