VHF K4 edition Originalbetriebsanleitung Seite 19

M4. Insert the tools into the tool positions of the tool mag-
azine:
Insert the tools straight into the tool positions and
„
push them in until the ring touches the rubber
( Fig. 16).

Fig. 16: Inserting tools straight into the tool position
The positions of the tools in the tool magazine must
„
match the tool positions in DentalCNC (
If the positions of the tools in the tool magazine do not
n
match the tool positions in DentalCNC, the machine
will use the wrong tool(s) during job execution and
the job result will become unusable.
90 °
Fig. 17).

Original Operating Instructions: K4 edition
Document version: E – 02/2020
1
7
Fig. 17: Top: tool positions 1 – 16 in the tool magazine
Bottom: tool positions 1 – 16 in DentalCNC
Running the machine
2
3
4
5
6
19