Changing The Storage Battery - Austroflamm Scotty Duo Betriebsanleitung

14 | Maintenance

14.4 Changing the storage battery

A CR2032 battery is located in the control unit. This battery enables the control unit to save certain
data - e.g. time, date, heating times etc. even during a power failure, or when the mains power supply
is disconnected.
If the battery is flat, the control unit will continue to function normally. However, in the event of a power
failure, the above-mentioned data will be lost. These data must then be saved afresh.
Fig. 88: Changing the storage battery
1 Cover
58
Change the battery every 2 years, as follows:
1) The battery is located on the central control unit. To
-
+
2
2) Use insulated pliers or a similar tool to remove the old
1
3) Insert the new battery, taking note of the correct po-
2 CR2032 storage
battery
EN
replace it, the right-hand side cladding of the hybrid
stove must first be removed. Then remove the cover
of the control unit.
battery from the holder.
larity.
Operating manual Scotty Duo