Austroflamm Scotty Duo Betriebsanleitung Seite 39

Operating manual Scotty Duo
Fig. 47: Hybrid start
Fig. 48: Log start I
Fig. 49: Log start II
EN
Hybrid start
Hybrid start is used for igniting the logvia pellet ignition. In
hybrid start, pellets are fed in and the damper doors for the
supply of combustion air are opened. This ensures the op-
timum burning of the inserted log.
TIP
Ensure that the combustion cavity is not completely
covered with log (danger of deflagration).
After a few minutes the stove switches to the "Log start I"
operating phase in order to further kindle the log.
If during the hybrid start the door is opened and closed
again and the "NO" is pressed on the display, the stove
switches back into pellet operation.
Log start I
After the hybrid start has finished, the stove switches to this
operating phase. Here it is ensured that all the pellets in the
combustion cavity are burning and the log is further
kindled.
If the door is opened and closed again while the stove is in
a non-operating condition (and the question "Have you in-
serted log?" on the display.has been answered with "Yes"),
the stove switches to the "Log start I" operating status.
In this operating phase, all damper doors are fully opened
and the exhaust gas fan runs at a specified speed. After a
certain firebox temperature has been reached and a certain
time has finished, "Log start II" is switched to.
If no temperature increase is detected, after a few minutes
the stove automatically switches again to the OFF state. The
stove does however note that log has been inserted (a small
green symbol is shown on the display). After the next pellet
ignition the stove automatically switches to hybrid start.
Log start II
In this operating status the riddling grate is opened after
approx. 2 minutes and thus the primary damper door
closed and the log further kindled until a certain firebox
temperature (depending on the set output level) is reached.
If this is reached, the stove switches into "Log operation"
status.
10 | Operation
39