Setup And Installation; Install/Remove Accessories - Cameo F1 FC Bedienungsanleitung

SETUP AND INSTALLATION

Thanks to its four plastic feet, the spotlight can be placed in a suitable location on a flat surface. Install on a crossbeam using the prein-
stalled mounting bracket (A) and a suitable crossbeam clamp (available as an accessory). Make sure that the spotlight is firmly attached and
secure it using a suitable safety cable on the designated location on the top of the spotlight (B). Use the lever screw (C) located on one side
to adjust the vertical radiation direction.
A distance of at least 0.1 m must be kept between objects or walls located beside, above and behind the spotlight; a distance of at least
0.5 m must be kept in front of the spotlight in the cone of light.
Warning: Overhead installation requires extensive experience, including the calculation of the load limit values of the installa-
tion material and regular safety inspection of all installation materials and spotlights. If you do not have these qualifications, do
not attempt to carry out the installation yourself; contact a professional company.
There is a risk that incorrectly mounted or secured devices may come loose and fall down. This may lead to serious injury and
even fatalities.
A
C

INSTALL/REMOVE ACCESSORIES

To install or remove the barn doors and the filter frame, please push the spring-loaded locking pin (D) of the bracket so that it folds upwards.
Do not forget afterwards to return the retaining bracket back to the original position so that the lock pins click back into their locked
position.
Warning: For safety reasons, the filter frame must always be in the respective bracket on the spotlight, even if no filter is
inserted!
Warning: Always secure the filter frame, and the barn door if used, to the spotlight using the enclosed safety cable!
D
B
15