Setup And Installation; Installation / Disassembly Of Barn Door And Filter Frame / Cleaning Of Lenses - Cameo F4 FC Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

SETUP AND INSTALLATION

Thanks to its four plastic feet, the spotlight can be placed in a suitable location on a flat surface. Install on a crossbeam using the prein-

stalled mounting bracket (A) and a suitable crossbeam clamp (available as an accessory). Make sure that the spotlight is firmly attached and

secure it using a suitable safety cable on the designated location on the top of the spotlight (B). Use the lever screw (C) located on one side

to adjust the vertical radiation direction.

A distance of at least 0.1 m must be kept between objects or walls located beside, above and behind the spotlight; a distance of at least

0.5 m must be kept in front of the spotlight in the cone of light.

Important safety information Overhead installation requires extensive experience, which includes calculating the limit

values of the working load of the installation material to be used and regular safety inspections of all installation material and

spotlights. If you do not have these qualifications, do not attempt to carry out the installation yourself; contact a professional

company.

Separate the device completely from the power supply. To mount or dismount the barn door and filter frame, press the spring-loaded locking

bolt (D) of the holding device so that it folds upwards. Do not forget afterwards to return the retaining bracket back to the original position

so that the lock pins click back into their locked position. The barn door's retention arm and filter frame on the bottom of the spotlight

are equipped with a second securing device (E) so that an additional safety cable for the barn door is not required. Once the barn door is

mounted on the spotlight, move the lever (E) on the bottom retention arm so that it is positioned parallel to the spotlight. The latch (F) will

then stop the barn door from sliding out of the retention arm. Rotate the lever 90° to open the securing device. Use the safety cable provided

to secure the filter frame.

Inhaltsverzeichnis

Cl4fc