Installation And Mounting - Cameo NANOBEAM 600 Bedienungsanleitung

Display = Display lighting
Display = Rotate display
invert
DMX fail = Operating status with DMX
signal fault
Software = Displays device software

INSTALLATION AND MOUNTING

Thanks to its pre-installed rubber feet, the spotlight can be positioned in a suitable location on the stage floor etc. Mounting on a traverse is
achieved with the supplied Omega bracket (only use original accessories) and a suitable traverse clamp (not included). Secure the device in
the selected position with a suitable safety cable. Do so by attaching the Omega bracket bolts to the base of the housing using a 5 mm hex
tool and the two M6 hexagon bolts. Attach the supplied M6 securing lug to the left or right of the Omega bracket.
Important note: Overhead mounting requires extensive experience, including the calculation of the load limit values of the
installation material and regular safety inspection of all installation materials and spotlights.
If you do not have these qualifications, do not attempt to perform an installation yourself. Refer instead to a qualified professional.
8
On Light permanently on
30 S Deactivates light after approximately 30 seconds of inactivity
No No display rotation
Yes Display is rotated through 180° (e.g. for overhead installation)
Auto Activates Auto mode
Black Activates blackout
Hold Last command is retained
V1.x