Instructions For Outdoor Installation Equipment - Cameo DURA SPOT Bedienungsanleitung

ATTENTION:
1. Do not install or operate the device near any radiators, heat registers, stoves or
other heat sources. Ensure that the device is always installed in such a way that it
is sufficiently cooled and cannot overheat.
2. Do not place ignition sources such as burning candles near the device.
3. Ventilation openings must not be covered and fans must not be blocked.
4. Use the original packaging or packaging provided by the manufacturer for trans-
port.
5. Avoid shock or impact to the unit.
6. Observe the IP protection class as well as the ambient conditions such as tempera-
ture and humidity according to the specification.
7. Devices can be constantly further developed. In the event of deviating informati-
on on operating conditions, performance or other device properties between the
user manual and the device labelling, the information on the device always takes
priority.
8. The unit is not suitable for tropical climates and for operation above 2000 m above
sea level.
9. Unless explicitly stated, the unit is not suitable for operation in marine conditions .
CAUTION! IMPORTANT INFORMATION REGARDING LIGHTING PRODUCTS!
1. Never look directly into the beam of light, not even for a short period of time.
2. Never look into the beam of light using optical devices such as a magnifying glass.
3. Stroboscopic effects may cause epileptic seizures in susceptible individuals!
4. Permanently installed lamps are built into these lighting units. These may not be
replaced by the user. In the event of a fault, please contact your sales partner.

INSTRUCTIONS FOR OUTDOOR INSTALLATION EQUIPMENT

1. Units for installation applications are designed for continuous operation.
2. Equipment for outdoor installation is largely weather-resistant. Depending on the
design, however, installed seals may be made of materials that deteriorate over
time. These must be checked regularly and replaced if necessary.
3. The correct condition of the housing parts and connections must be checked
regularly.
4. Surfaces and plastic parts can also weather in installation equipment, e.g. due to
UV irradiation. This generally does not impair functionality.
5. Damage to the surface coating can impair the device's corrosion protection.
Damaged surface coating (e.g. scratches) must be promptly repaired by suitable
measures.
6. Screw connections can be impaired in their freedom of movement (e.g. due to
oxidation or impurities). Here, appropriate measures for loosening are to be imple-
mented.
7. Unless explicitly stated otherwise on the device or in the technical data, the devices
are intended for installation heights of less than 5 m.
9