Before Use; Charging The Battery Pack (See Fig. A); Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level - Parkside PABS 20-LI B2 Originalbetriebsanleitung

Before use

Charging the battery pack (see fig. A)
CAUTION!
► Always pull out the plug before you remove
the battery pack
battery pack to the charger.
■ Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
♦ Connect the battery pack
tery charger (see Fig. A).
♦ Insert the power plug into the socket. The con-
trol LED lights up red to indicate that the
appliance is charging.
♦ The green control LED
charging process is complete and the battery
pack is ready.
♦ Insert the battery pack
ance (see Fig. B).
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Push the rotation direction switch
middle position (lock) (see Fig. C). Allow the bat-
tery pack to click into the handle (see Fig. B).
Removing the battery pack:
♦ Press the release button
tery pack (see Fig. D).

Checking the battery charge level

♦ Press the battery charge level button
the charge level of the battery (see Fig. E). The
status/remaining charge will be shown on the
battery display LED
♦ GREEN/RED/ORANGE = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
│ GB │ IE
■ 6
All manuals and user guides at all-guides.com
from or connect the
when the
to the rapid bat-
indicates that the
back into the appli-
into the
and remove the bat-
to check
as follows:

Changing tools

Your cordless drill has a fully automatic spindle
lock .
When the motor is stopped, the power train locks
so that the chuck can be opened by turning
it . After you have attached the desired tool
and tightened it by turning the chuck
continue working (see Fig. F). The spindle lock is
automatically released when the motor starts (ON/
OFF switch pressed).

Torque selection ring/drill setting

You can set the torque using the torque selection
ring (see Fig. G).
♦ Select a low level for small screws or soft materials.
♦ Select a high level for large screws, hard materi-
als or removing screws.
♦ Select the drill setting for drilling work by adjust-
ing the torque selection ring
(see Fig. H).

2 speed gearbox

CAUTION!
► Only operate the gear selection switch
when the appliance is at a standstill. Other-
wise the appliance can be damaged.
In first gear (gear selector switch
tion: 1) (see Fig. I)
you can reach a speed of approx. 400 rpm and a
high torque. This setting is suitable for all screwing
jobs.
In second gear (gear selector switch
position: 2) (see Fig. J)
you can reach a speed of approx. 1400 rpm for
carrying out drilling work.
, you can
to the position
in posi-
in
PABS 20-LI B2