Potential Hazards During Electric Arc Welding - Parkside PMSG 200 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Safety instructions
ATTENTION!
During the operation of the

welding device, other con-
sumers may experience prob-
lems with the voltage supply
depending on the network
conditions at the connection
point. In case of doubt, please
contact your energy supply
company.
During the operation of the

welding device, other devices
may malfunction, e.g. hearing
aids, cardiac pacemakers, etc.
 Potential hazards
during electric arc
welding
There are a series of potential
hazards that can occur during
electric arc welding. It is there-
fore particularly important for the
welder to observe the following
rules to avoid endangering him/
herself and others and to pre-
vent damage to people and the
device.
Work on the voltage side, e.g.

on cables, plugs, sockets etc.,
may only be carried out by
qualifi ed electricians accord-
ing to national and local
regulations.
12 GB/CY
In the event of accidents,

disconnect the welding
device from the mains voltage
immediately.
If electrical contact voltages

occur, switch off the device
immediately and have it
checked by a qualifi ed
electrician.
Always ensure good electrical

contacts on the welding current
side.
Always wear insulating gloves

on both hands during welding
work. These provide protection
from electrical shocks (no-load
voltage of the welding cur-
rent circuit), harmful radia-
tions (heat and UV radiation)
and incandescent metal and
splashes of slag.
Wear sturdy, insulating shoes.

The shoes should also insulate
when exposed to moisture.
Loafers are not suitable as
falling incandescent metal
droplets can cause burns.
Wear suitable protective

clothing, no synthetic
garments.
Do not look into the electric

arc without eye protection;
only use a welding mask with
the prescribed protective glass
as per DIN. In addition to light