Safety Instructions - Parkside PMSG 200 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Introduction / Safety instructions
Accordingly, no warranty is offered for
the physical dimensions, information
and specifi cations in these operating
instructions. The operating instructions
cannot therefore be used as the basis
for asserting a legal claim.
Note:
The use of the term 'device' in the
following text refers to the multi-welder
described in this instruction manual.

Safety instructions

Please read the operating instruc-
tions with care and observe the
notes described. Familiarise your-
self with the device, its proper use
and the safety instructions based
on these operating instructions.
The rating plate contains all tech-
nical data of this welding device;
please learn about the technical
features of this device.
packaging material away from
small children. There is a risk of
suffocation!
This device may be used by

children aged 16 years and
older, and by persons with
reduced physical, sensory or
mental capacities, or a lack of
experience and knowledge,
if they are supervised or have
10 GB/CY
Keep the
been instructed in how to use
the device safely and under-
stand the dangers that may
arise when using it. Do not
allow children to play with the
device. Cleaning and day-to-
day maintenance must not be
performed by children without
supervision.
Repairs and/or maintenance

work must only be carried out
by qualifi ed electricians.
Only use the welding cables

(PMSG 200 A1 H01N2-
D1x16 mm²) included in the
scope of delivery.
During operation, the device

should not be positioned
directly on the wall, covered or
jammed between other devices
so that suffi cient air can be
absorbed through the ventila-
tion slats. Make sure that the
device is correctly connected
to the supply voltage. Avoid
any form of tensile stress of
the power cable. Disconnect
the plug from the socket prior
to setting up the device in
another location.
If the device is not in opera-

tion, always switch it off by
pressing the ON/OFF switch.
Place the electrode holder on
an insulated surface and only