Safety Instructions - Parkside PMSG 200 A1 Montage-, Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Safety instructions

Safety instructions
Please read the operating instruc-
tions with care and observe the
notes described. Familiarise
yourself with the device, its
proper use and the safety notes
based on these operating instruc-
tions. The rating plate contains
all technical data of this welding
device; please learn about the
technical features of this device.
packaging material away from
small children. There is a risk of
suffocation!
This device may be used by
„
children aged 16 years and
older, and by persons with
reduced physical, sensory or
mental capacities, or a lack of
experience and knowledge,
if they are supervised or have
been instructed in how to use
the device safely and under-
stand the dangers that may
arise when using it. Do not
allow children to play with the
device. Cleaning and day-to-
day maintenance must not be
performed by children without
supervision.
66
GB/MT
Keep the
Repairs and/or maintenance
„
work must only be carried out
by qualified electricians.
Only use the welding cables
„
(PMSG 200 A1 H01N2-
D1x16 mm²) included in the
scope of delivery.
During operation, the device
„
should not be positioned
directly on the wall, covered or
jammed between other devices
so that sufficient air can be
absorbed through the ventila-
tion slats. Makes sure that the
device is correctly connected
to the supply voltage. Avoid
any form of tensile stress of
the power cable. Disconnect
the plug from the socket prior
to setting up the device in
another location.
If the device is not in opera-
„
tion, always switch it off by
pressing the ON/OFF switch.
Place the electrode holder on
an insulated surface and only
remove it from the holder
after allowing it to cool down
for 15 minutes.
Pay attention to the condition
„
of the welding cable,
electrode holder and the earth
terminal. Wear and tear of
the insulation and the live
parts can lead to hazards and