Start Up; Simple Operating Functions On The Device - HomeMatic HM-LC-Sw1-SM Bedienungsanleitung

HM-LC-Dim2T-SM
L External conductor connection
N Neutral connection
PE PE connection
Dimmed phase channel 1
N Neutral line channel 1
Dimmed phase channel 2
N Neutral line channel 2
50
Permitted wire cross-section for connecting to the AP
actuators:
Rigid wire Flexible wire
[mm ] without end
2
sleeve [mm
0.50 – 2.50 0.50 - 2.50
7

Start up

7.1 Simple operating functions on the
device
There is one control button per channel on the devices
(one UP button and one DOWN button for the blind
actuator). You can operate the actuator immediately
(teaching is not required) and check for correct
electrical installation. With switching and dimming
actuators, you can use it to switch the channel on and
off. With blind actuators, you can move the hangings
up or down.
Only the brief button press is used for
operation. The longer button press (holding
longer than 4 seconds) switches the actuator to
teach mode.
Flexible wire
with end sleeve
] [mm ]
2 2
0.50 – 2.50
51