Checking The Battery Charge Level; Cleaning; Maintenance And Storage - Parkside PLG 20 C1 Originalbetriebsanleitung

ATTENTION!
♦ If the red control LED
pack has overheated and cannot be charged.
♦ If the red and green control LEDs
that the battery pack
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes between successive
charging sessions. Also disconnect the power plug from the mains
power socket.

Checking the battery charge level

♦ Press the battery charge level button
the battery (see also main diagram). The status/remaining
charge will be shown on the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Cleaning

CAUTION!
► Always unplug the charger before cleaning it.
► Do not clean the charger with water.
■ Clean the appliance with a dry cloth or brush. Do not use water
or metallic objects.

Maintenance and storage

■ If you do not intend to use the appliance for an extended period,
remove the batteries and store it in a clean, dry place away from
direct sunlight.
│ GB │ IE │ NI │ CY
■ 8
flashes, this means that the battery
is defective.
into the appliance.
to check the status of
both flash, this means
as follows:
PLG 20 C1