Charging Process; Checking The Charge Status Of The Rechargeable Battery - Parkside PDSLG 20 A1 Originalbetriebsanleitung

Dirt and the entry of water in-
crease the risk of electric shock.
• The charger may only be
used with the corresponding
rechargeable batteries of the
Parkside X 20 V Team series.
Charging other batteries may
result in injuries and risk of fire.
• Avoid mechanical damage to
the charger. This can result in
internal short circuits.
• Do not operate the charger on a
combustible surface (e.g. paper,
textiles). Risk of fire due to heat-
ing during charging.
• Charge the batteries only in
chargers that are recommended
by the manufacturer. Risk of fire
if a charger that is suitable for a
specific type of battery is used
with other batteries.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not use the charger to
charge non-rechargeable bat-
teries. The device could become
damaged.

Charging Process

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry
room only.
Prior to attaching the charg-
er, check that the battery's
outer surface is clean and
dry.
There is a risk of injury due
to electric shock.
• Charge the battery before the first time
of use.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
Checking the charge status
of the rechargeable battery
The battery charge status indicator (3)
signalises the state of charge of the battery
(4).
Press the button (2) on the battery. The
state of charge of the battery is displayed
by illuminating the 3-colour LED lights of
the state of charge display.
3 LEDs light up (red, orange and green):
Battery is fully charged.
2 LEDs light up (red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged
GB MT
25