Manual Tare Function; Zero On Start-Up - HBM DIS2116 Kurzanleitung

24
Execution is dependent on standstill recognition (Chapter 7.9, page 25).
Taring with this key overwrites any manual tare value that may have been ent-
ered previously (PT symbol is switched off).
Entering manual tare value
Pressing the F3 key for more than 2 s displays a window for input of a manual
tare value. Upon entry of a manual tare value, the net value plus manual tare
is displayed (NET PT).
NOTE
Taring and entry of a manual tare value is only possible when the function in
the "PARAMETER MENU → FUNCTION KEYS → TARING" is set to ACTIVE.

7.6 Manual tare function

A manual tare value can be input in the parameter menu "SCALE PARAME-
TERS-PARAMETER-MANUAL TARE VALUE" and the calculation of the ma-
nual tare value can be switched on/off in the parameter menu "SCALE PARA-
METERS-PARAMETER-MANUAL TARE MODE", (see system CD).
When the "Manual tare" function is active, the net value is formed by deduc-
ting a fixed tare value.
The "G/N" key does not change the entered manual tare value.
The .PT. symbol in the display indicates that the net value has been formed by
deducting the manual tare value. This disappears after taring with the key F3
(">T<").
If the tare function was activated, it will also be activated once the device is
switched back on.

7.7 Zero on start-up

If this function is activated (parameter menu "SCALE PARAMETERS → PARA-
METER → ZERO ON START-UP"), the unloaded scale is automatically set to
zero when the DIS2116 is switched on (range of zero setting device ±2...20 %).
This takes into consideration the set standstill condition.
HBM
DIS2116
A2540-1.1 en/de