Center Of Gravity - HBM DIS2116 Kurzanleitung

DIS2116
F1
w
This function can be used to look at a section of the recorded measured va-
lues. To do this, position CURSOR 1 with the keys F1, F2 at the start and
CURSOR 2 with the keys F3, F4 at the end of the area of interest. The mea-
sured values along the Y axis will be zoomed in on. The MAX value and the
MIN value of the section observed will be displayed on the Y axis.
Return to the entire recording by placing CURSOR 1 on the left edge and
CURSOR 2 on the right edge.
Use CE to leave the FOCUS function and reset the CURSOR 1 (2) so that
when F1 is pressed again, they will be positioned on the left and right edges.
F2
w
Keys F1 and F4 can be used to select various measured values and display
them in the line graphic.
1. Select the required signal (meas. value) with F1 and F4 and confirm with
2. Leave the measured value selection menu with CE.
The selected signal will be displayed in the recording window in the upper
right corner. The abbreviations:
M = Measured value of the scale
S: 1..3 = Segment with segment number
A:11 = Signal of a single load cell indicated by the address

10.2 Center of gravity

The center of gravity of a loaded scale is displayed. The scale must consist of
at least 3 load cells to display the center of gravity.
Access: Key
,
CENTER OF GRAVITY
ADR 11
ADR 14
Display illustration: Center of gravity
A2540-1.1 en/de
FOCUS
MEASURED VALUE
I
INFORMATION
(Enter)
X
GRAPHIC
ADR 12
ADR 13
33
.
HBM