Initial Commissioning; Nawi Application - HBM DIS2116 Kurzanleitung

DIS2116
Mechanical dimensions are described in chapter 14 (page 43 ) and mounting
information in chapter 3, page 7 .
Subsequent sub-chapters provide an overview of the sequence of steps that
need to be taken to commission the scale, depending on the application:

• Initial commissioning

• As a component of a non-automatic scale (NAWI)
• As a component of a vehicle scale ³ Chapter 4.3 (page 10)
This overview includes information on the respective chapters in this Opera-
ting Manual.
1)
NAWI – non automatic weighing instrument
4.1 Initial commissioning
• Mounting the device, Chapter 3 (page 7)
• Connecting the digital load cell(s), Chapter 5 (page 11) and 5.4 (page 14)
• Connecting the supply voltage, Chapter 5 (page 11) and 5.5 (page 14)
• Connecting the serial connections, Chapter 5 (page 11), 5.8 (page 15) or
5.9 (page 16)
• Switching on the device, Chapter 7.2 (page 22)
• Configuration of the load cells, Chapter 10.1 (page 32)

4.2 NAWI application

• Mounting the device, Chapter 3 (page 7)
• Connecting the digital load cell(s), Chapter 5 (page 11) and 5.4 (page 14)
• Connecting the supply voltage, Chapter 5 (page 11) and 5.5 (page 14)
• Connecting the serial connections, Chapter 5 (page 11), 5.8 (page 15) or
5.9 (page 16)
• Switching on the device, Chapter 7.2 (page 22)
the following steps are described on the system CD
• Calling the parameter menu via the hidden key
• Enabling all menu functions
• Configuration of the load cells
• Setting the weighing range
• Setting the correct filters
• Adjusting the weighing range
• Digital off-center load compensation (if necessary)
A2540-1.1 en/de
³ Chapter 4.1 (page 9)
1)
9
HBM