Inogen Rove 6 Bedienungsanleitung Seite 20

Step Instruction
Connect your concentrator to an appropriate
7.3.2
power source
IMPORTANT: Using the wrong cords can lead to a fire.
Only use compatible cords from the manufacturer.
It is recommended to keep a battery always installed
on the device, as the battery will charge when the
concentrator is plugged into external power. To install
a battery:
2.1 Align the battery with the bottom housing of the
device.
2.2. Slide the battery into place until you hear an audi-
ble click, meaning the latch has returned to the
upper position.
2.3. You will hear a single beep and you will see the
indicator lights and display light up briefly before
shutting off. This means the concentrator has suc-
cessfully been connected to your battery.
DO NOT use a battery other than those specified in
this manual.
If using AC power, do the following:
2.4 Connect the AC power brick to the power supply
cable.
2.5 Plug the power supply cable into a standard wall
outlet.
2.6 Insert the power supply cable into the power port
located near the particle filter on the back of the
concentrator.
2.7 You will hear a single beep and you will see the
indicator lights and display screen light up briefly
before shutting off. This means the concentrator
has successfully been connected to your power
supply.
DO NOT use a power supply other than those speci-
fied in this manual.
DO NOT use power cables, or accessories other than
those specified in this manual.
©2022 Inogen, Inc. All rights reserved. Page 20 of 356 96-12100-01-01-A