Assembly And Installation - EHEIM pHcontrol+ 6062 Bedienungsanleitung

English
‧ We recommend protecting all electrical aquarium appliances via a residual current
protective device with a rated residual current of 30 mA maximum.
‧ If they are not being used, always disconnect all devices in the aquarium from
the power supply before you install/remove any parts and before all cleaning and
maintenance work.
‧ Protect the mains socket and power supply unit against
moisture and wetness. A drip loop must be formed with the
cable of the power supply unit. This prevents any water
running along the cable to the mains socket, which would
result in a short-circuit.
‧ The electrical data of the power supply unit must match
the data of the power mains. This data is found on the type
plate, the packaging and in these instructions.
‧ This appliance is operated without an earth connection.
‧ Only use the power supply unit that has been supplied with the appliance. If it
needs to be replaced, then an original EHEIM power supply unit has to be used.

Assembly and installation

Placing the pH controller
CAUTION! Material damage due to moisture.
▶ The pH controller must not be placed underneath the aquarium cover.
1. Choose a suitable place for the pH controller ① (⌦A).
Observe the following cable lengths:
pH controller – magnetic valve approx. 1.5 m
pH controller – pH sensor approx. 2 m
A mounting strap ⑪ can be found on the back of the pH controller (⌦J).
2. Insert the plug of the power supply unit into the socket of the pH controller (⌦B).
24
Drip Loop